Guest guest Posted October 2, 2002 Report Share Posted October 2, 2002 HEPA Respirators and Mold Spores + Mycotoxins Dr. L. Lipsey, Toxicologist I received an e-mail today from Dr. Gray questioning the effectiveness of HEPA respirators for people working in mold contaminated buildings. It deserves serious consideration. Remember when charcoal respirators were approved for auto spray painting and then NIOSH spent over 10 years trying to convince Dupont, and other paint mfg's producing auto paint containing TDI and HDI (diisocyanates), to required SCBA respirators (supplied air) in their MSDS warnings. This information from Dr. Gray, warning of the possibility that smaller spores as well as mycotoxins may be getting thru or around HEPA respirators, could be analogous ( see below ) _____________________________________________________________________ , The size range for mold spores ranges from approximately 7 micra down to 0.03 micron. HEPA filters generally are effective down to 0.3 micra. And that the last time I had a discussion with Cliff Crutchfield, Ph.D., industrial hygienist at the Univ. of Az., he stated that respirable particles were not effectively filtered by passive filtration devices. I believe that this was because of the difficulty maintaining a seal with even have days beard growth for men, and small face sizes for women.I also expressed concern for the inhalation of mycotoxins, the prevention of which would require some form of compound, forced air respirator. Form the data that I am seeing on the neurotox side of the equation, and from the experience of many of the patients that I have evaluated regarding small airways inflamation, and immune toxicity phenomena, I believe that until the nature of the exposure is characterized by identifying the intensity of the exposure to both mold spores, and mycotoxins, the risk is too great to warrant less than forced air respirators with multi bank, compound filters: HEPA, zeolite, charcoal or self contained clean air sources.If you think that is to stringent, let me know. Thanks, DocMike007 (Dr. Gray, Benson Dr. L. Lipsey Professor and Toxicologist University of North Florida U. of Florida Med. Ctr, Jax Poison Control Center Board CV--Toxicology And Environmental Health Assoc. HEPA Respirators and Mold Spores + Mycotoxins Dr. L. Lipsey, Toxicologist I received an e-mail today from Dr. Gray questioning the effectiveness of HEPA respirators for people working in mold contaminated buildings. It deserves serious consideration. Remember when charcoal respirators were approved for auto spray painting and then NIOSH spent over 10 years trying to convince Dupont, and other paint mfg's producing auto paint containing TDI and HDI (diisocyanates), to required SCBA respirators (supplied air) in their MSDS warnings. This information from Dr. Gray, warning of the possibility that smaller spores as well as mycotoxins may be getting thru or around HEPA respirators, could be analogous ( see below ) _____________________________________________________________________ , The size range for mold spores ranges from approximately 7 micra down to 0.03 micron. HEPA filters generally are effective down to 0.3 micra. And that the last time I had a discussion with Cliff Crutchfield, Ph.D., industrial hygienist at the Univ. of Az., he stated that respirable particles were not effectively filtered by passive filtration devices. I believe that this was because of the difficulty maintaining a seal with even have days beard growth for men, and small face sizes for women.I also expressed concern for the inhalation of mycotoxins, the prevention of which would require some form of compound, forced air respirator. Form the data that I am seeing on the neurotox side of the equation, and from the experience of many of the patients that I have evaluated regarding small airways inflamation, and immune toxicity phenomena, I believe that until the nature of the exposure is characterized by identifying the intensity of the exposure to both mold spores, and mycotoxins, the risk is too great to warrant less than forced air respirators with multi bank, compound filters: HEPA, zeolite, charcoal or self contained clean air sources.If you think that is to stringent, let me know. Thanks, DocMike007 (Dr. Gray, Benson Dr. L. Lipsey Professor and Toxicologist University of North Florida U. of Florida Med. Ctr, Jax Poison Control Center Board CV--Toxicology And Environmental Health Assoc. HEPA Respirators and Mold Spores + Mycotoxins Posted by Dr. L. Lipsey, Toxicologist I received an e-mail today from Dr. Gray questioning the effectiveness of HEPA respirators for people working in mold contaminated buildings. It deserves serious consideration. Remember when charcoal respirators were approved for auto spray painting and then NIOSH spent over 10 years trying to convince Dupont, and other paint mfg's producing auto paint containing TDI and HDI (diisocyanates), to required SCBA respirators (supplied air) in their MSDS warnings. This information from Dr. Gray, warning of the possibility that smaller spores as well as mycotoxins may be getting thru or around HEPA respirators, could be analogous ( see below ) _____________________________________________________________________ , The size range for mold spores ranges from approximately 7 micra down to 0.03 micron. HEPA filters generally are effective down to 0.3 micra. And that the last time I had a discussion with Cliff Crutchfield, Ph.D., industrial hygienist at the Univ. of Az., he stated that respirable particles were not effectively filtered by passive filtration devices. I believe that this was because of the difficulty maintaining a seal with even have days beard growth for men, and small face sizes for women.I also expressed concern for the inhalation of mycotoxins, the prevention of which would require some form of compound, forced air respirator. Form the data that I am seeing on the neurotox side of the equation, and from the experience of many of the patients that I have evaluated regarding small airways inflamation, and immune toxicity phenomena, I believe that until the nature of the exposure is characterized by identifying the intensity of the exposure to both mold spores, and mycotoxins, the risk is too great to warrant less than forced air respirators with multi bank, compound filters: HEPA, zeolite, charcoal or self contained clean air sources.If you think that is to stringent, let me know. Thanks, DocMike007 (Dr. Gray, Benson, AZ) Dr. L. Lipsey Professor and Toxicologist University of North Florida U. of Florida Med. Ctr, Jax Poison Control Center Board CV--Toxicology And Environmental Health Assoc. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.