Guest guest Posted December 16, 2008 Report Share Posted December 16, 2008 I just went down and bought some button batteries and 2 holders. The holders have a sort of clip on one side to hold the batteries, and 2 tiny pins on the other side. The bag says for " crowded boards " . I'm assuming that means these pins will pop into 2 holes on the boards. So, is this where I solder the wire on to? Because I only need one wire, I m assuming I will need to get the multiple strand wire, separate one end in half and solder each half to a pin. Or will I just use one pin? And each button holder has the same marking for positive battery placement inside the holder. Would I need to turn one button so that the negative side is facing the clip, or is it ok to have both button's positive side facing the clips? Looking forward to doing this new pocket Godzilla. :-) Samala, Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.