Guest guest Posted February 24, 2011 Report Share Posted February 24, 2011 Ran across this and thought it could be helpful. "A standard single gang pot is shown in Figure 5. The important external bits are shown so you can refer to them as needed. I have (somewhat arbitrarily) numbered the terminals as 1, 2 and 3. Terminal 2 is the wiper. For a "standard" volume control application, 1 is normally connected to ground, the input is applied to 3, and the output taken from 2 (wiper) allowing the output to be varied from ground (no signal) to input (maximum signal)."The full article is at: /post?referer=/group//join%3fyguid%3d114826001%26finish%3dmod & use_rte=1But most of it just confused me.Ron Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.