Guest guest Posted August 14, 2011 Report Share Posted August 14, 2011 aw..ok...get the new sponges. the little zits are areas the electrons have been too hard too many, etc. They tend to signal the body to send fluid to cool it off..but the fluid only allows MORE electrons, so the cycle starts building up till there's a minor burn. The zits are micro-burns, in other words. you might trim the wire length inside sponges see if that helps. Also add some distilled water to final rinse to reduce conductivity. meter is good idea if you want to better understand and control it. Also, cut total time down will tend to reduce these. I got huge " zits " 1/4 inch across and deep enough to reach almost into blood vessels when overdoing wrist electrification. 3 of them on same wrist. Now healed over with scars, but otherwise no permanent damage...hold on I have to call the Mother Ship... bG > > All of a sudden, my 'usual and customary' use of the 2 sponges with 6 volt battery has resulted in some tiny 'zit' type thingies on both the cheeks and behind the neck. I have not taken the time to put the meter in the line so have just decided to change the sponges and see what happens. Over time my sponges have gotten a bit dirty. I don't always clean my face before use so I think gunk has accumulated here and there and that's probably the cause. I use it a lot for dental problems. I have also been using it 10 min. before changing sides so will reduce that to 5 min. again. Laziness exacts a toll! pj > Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.