RE: Re: Hair test results---Dana B Lyme/Mold considerations

[Guest guest]

From: frequent-dose-chelation

[mailto:frequent-dose-chelation ] On Behalf Of mercurybeater

Hi -

>>Dana

>>Some thoughts may be irrelevant\

>>A)Do you have your final small amalgam filling out

>> if yes, I presume you are chelating

>>C)have you looked at thyroid and adrenal support

-------- I still have the one little filling and also need to get my crowns

checked before starting chelation. I did a trial of hydrocortisone, which

seemed to cause more problems. Dave said he doesn't see any indication of

adrenal problems. My temp does run a little low, but I'm almost never cold

(though I do have little tolerance for either too hot or too cold). I did

trials with thyroid a couple of times in the 90s but may not have done it

properly (docs weren't too knowledgeable).

>>D) I have clinically tested poistive for lymes (had 4-5 bands on the

Igenex tests which most lyme Dr's only use as a reference anyway's as

its so unreliable). and have the poor genes for lymes and mold

I am rethinking what I have said ealier on this forum in getting rid

of more mercury before i went after the lymes.

>> That is my persoanl feeling is that in mercury chelation or any level

of detoxing for that matter , layers of previous infections (lymes,

viral, bacteria, etc) get re-released and become part of our

toxicity...Dunno yet what i am going to do to go after these

beasts/bugs but it will be something

>> In your case if you have been tested as postive I think i would be sure to

try and treat the lymes in some way.

---------- My positive Lyme test was from Bowen Labs (no longer available)

and the titer was very low. I've been treating for Lyme for over 2 years

with no change.

>> I was going to try the salt-C combination BUT Do Not think this much

salt everyday (about 4 teaspoons) is a good idea

---------- You would likely *never* need so much salt. The protocol

recommended on Lymestrategies is to start with 1 or 2 grams each salt and C

and scale up slowly. Very few get up to 4 teaspoons salt (that would be

around 20+ grams). The protocol listed on lymephotos.com is much too

aggressive for most people. If you join Lymestrategies and read link #4

you'll see the recommended protocol. Many have recovered using this

protocol, but complicating factors (such as heavy metal toxicity or

co-infections keep some from recovering).

>> I am DEAD agaisnt antibiotics for right now as I choose to believe

the research whcih says antibiotcs are limited in their benefit when

you are merccury toxic and only make the beasts/bugs more antibiotic

resistance

>> I am actually going to go back and do an actos/cholestyramine

round or two.

>> I initially got quite ill when I moved to this building in downtown

SF, so given my mold/lyme deficiency I am going to try this treatment

again. I just went on a 5 day vacation to arizona and felt fine until

I came back..I always notice I am feeling worse in my office BUT have

until recently attributed it to only the higher EMFs (electro-magetic

frequencies)..who knows maybe its the lyme /mold connection

---------- If you have the genetic defect for breaking down Lyme toxins, you

shouldn't work (or even be) anywhere there's mold.

>> I may try the rife angle as well

>> However this past week my lower neck is aching and burning like it

did a few years ago when I belive my lymes/mold. was more active

and my eyes are really starined. I know it could be just effects of

mercury but think its a little different

--------- My eyes have been bothering me for the past week as well. This is

a new symptom for me. I've been using colloidal silver eye drops, but so far

it isn't helping too much.

>> I tend to believe in the Tietelbaum approach which says you should

try to treta everything cause its all tied together. I know this is

much harder and more expensive

---------- I never connected too much with Tietelbaum. I'm going up to

Seattle the first week in May to see . I'm looking forward to

letting an expert help me instead of trying to figure out this whole

complicated mess myself.

wrote:

>

> Hi all-

>

<snip>